Meet Daniel Evans

Studio -
Colby Knox
More Information
Released - Apr 2024
Duration - 42 minutes
Studio -
Colby Knox
Director -
Colby Knox
Say hello to Dan Evans, this week’s sexy new “ride.” “Isn’t he fucking beautiful,” Mickey says to the audience. Hard to disagree with that appraisal. Everything starts perfectly between them with kissing. Both hotties wear shorts and are on the studio’s bed. Dan’s tool is ready to burst through his shorts; Mickey fixes the problem by removing them. Mickey’s shorts are also tossed aside. He kisses his way down Dan’s chest and stomach, stopping to devour the rigid rod. “Fuck. It feels so good,” Dan whispers. As his tool is sucked on, Dan’s fingers play with Mickey’s tight little ass. Mickey gets on his stomach so Dan can lick the hairy hole. After lubing up, Dan carefully mounts Mickey. Bare and right to the balls. After giving Mickey a chance to get used to the size of his wood, Dan hammers home. “Fucking give it to me,” Mickey begs. Dan does and Mickey loudly whimpers. As he invades Mickey’s insides, Dan leans down for passionate kissing. Mickey positions himself on his hands and knees. “Shove your fat cock in me,” he cries. He turns over. On his back. When Dan re-enters, Mickey groans with pleasure. Dan pounds deep, hard, and steady. Dan folds Mickey in half and drills down. As Mickey calls out, Dan covers him with kisses. “Fucking pin me down,” Mickey implores. “Fuck. You’re so deep.” It’s time for Mickey to do a little riding. Dan gets on his back and Mickey sits on the rigid tool. As he goes up and down, Dan holds Mickey’s meat. He takes back control by grabbing Mickey’s hips and fucking up All of that bucking and riding causes Mickey to shoot streams of cum, landing on Dan’s face and chest. Mickey scoops some of the juice up to taste, remaining impaled on the johnson. Dan pops next, kneeling over Mickey’s outstretched tongue. His load lands right on Mickey’s mouth. He gulps down Dan’s dick, licking it clean of all the remaining man milk. After some sloppy kissing, Dan asks a very important question. “When is round two?”